Perun for Krytac Kriss Vector replaces the standard electronics in the Kriss Vector airsoft replicas made by the Krytac company.

LIST OF FEATURES:

- Freely programmable fire modes: set any firing mode you like to any of the selector positions independently. The available modes are: safe, semi, binary, 2 to 5 round burst and automatic.

- Active brake: the active brake stops the engine after each shot, preventing spring compression or in case of replicas with high rate of fire, overspin (double shot problem).

- Precocking: A quick trigger response can be a matter of victory or defeat, especially in CQB situations. With precocking enabled, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after pulling the trigger. To release the spring after using preload, pull and hold the trigger. A second shot will be fired after 3 seconds, without precocking and fully braked.

- Rate of Fire Reduction: Automatically reduce rate of fire or explode fire to save ammo or trigger the replica more realistically.

- Low voltage alarm: Dedicated for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be turned on and off freely.

- Diagnostic system: Constantly monitors the replica and the mosfet itself. If there is a problem, it immediately informs you what it might be, making troubleshooting a lot easier.

- Electronic fuse: it will save your replica and battery in case of serious malfunction. It will automatically disconnect the battery if a short circuit or blocked motor is detected.

The programming of all the settings is done exclusively by means of a trigger and a selector, in sequences that can be easily memorized and quickly. Programming is supported by sound signals and multicolored LED diode. This allows you to change settings at any time, in seconds, even under enemy fire.