PERUN V3 HYBRID UNIVERSAL CABLES

It replaces the mechanical contacts in your airsoft replica or gel blaster and offers many additional features
optical and magnetic sensors eliminate many moving parts subject to damage, thus increasing reliability.
Adaptive trigger control allows you to switch from very short to long trigger stroke even in the field, with almost any trigger, including stock ones.
It works without the need for any modification with most gearbox v2 in the Tokyo Marui standard.
for details and exceptions refer to the manual.

LIST OF FEATURES:

- Adjustable trigger sensitivity: the trigger can be set to 5 sensitivity levels, ranging from a very short pull needed to fire a shot, to a very long one. No modification to the trigger or gearbox is required, and changing the sensitivity of the trigger is also possible in the field.

- Adjustable fire mode: Program the firing modes as you like, setting safe, semi, burst or automatic on both selector positions.

- Active brake: the active brake stops the engine after each shot, preventing spring compression or in case of replicas with high rate of fire, overspin (double shot problem).

- Precocking: A quick trigger response can be a matter of victory or defeat, especially in CQB situations. With precocking enabled, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after pulling the trigger. To release the spring after using precocking, press the trigger and hold it for 2 seconds, after which a second shot will be fired, this time without precocking and fully braked.

- Two-stage trigger: A light pull of the trigger is achieved with a single shot or burst, while a deeper pull will cause a burst or fully automatic fire. The following modes are available: semi - burst, semi - auto and burst - auto.

- Binary Trigger: Allows you to easily perform double shots in semi-automatic mode. After enabling this mode, if semi-automatic fire is set, the shots will be fired not only when the trigger is pulled, but also when it is released.

- Rate of Fire Reduction: Automatically reduce rate of fire or explode fire to save ammo or trigger the replica more realistically.

- DMR mode: Introduces intervals between semi-automatic shots to respect the DMR rules on some fields.

- Low voltage alarm: Dedicated for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be turned on and off freely.

- DSG: A sector gear sensing mode specially prepared to work with dual sector gears.

- Diagnostic system : Constantly monitors the replica and the mosfet itself. If there is a problem, it immediately informs you what it might be, making troubleshooting a lot easier.

- Electronic fuse: it will save your replica and battery in case of serious malfunction. It will automatically disconnect the battery when a short circuit or blocked motor is detected.

Programming of all settings is done exclusively using quick and easily memorable sequences of fire selector switching and trigger pulls supported by beeps and multi-colored LEDs. This allows you to change settings at any time, in seconds, even under enemy fire. All settings are set independently for each switch position, so you can program the MOSFET exactly how you want, for example semi on semi and binary trigger on auto.