ETU DEDICATED FOR G&G ARMAMENT RIFLES
With T-DEANS connector
It allows you to add multiple functions compared to the original G&G ETU
For G&G replicas only, it supports 7.4V, 11.1V and 14.8V batteries

LIST OF ADDITIONAL FEATURES:

- Independently programmed firing modes: program firing modes as you like, setting safe, semi, burst or automatic on both selector positions.

- Active brake: the active brake stops the engine after each shot, preventing the compression of the spring or in case of replicas with a high rate of fire, overspin (double hit problem).

- Precocking: A quick trigger response can be a matter of victory or defeat, especially in CQB situations. With pre-arming enabled, the piston will remain in the rear position after each shot with the spring already compressed, ensuring that the next shot is fired immediately after the trigger is pulled. To release the spring after using the pre-arm, press the trigger and hold it for 2 seconds, after which a second shot will be fired, this time without pre-arm and fully braked.

- Binary Trigger: Allows you to easily perform double shots in semi-automatic mode. After enabling this mode, if semi-automatic fire is set, the shots will be fired not only when the trigger is pulled, but also when it is released.

- Rate of Fire Reduction: Automatically reduce rate of fire or explode fire to save ammo or trigger the replica more realistically.

- DMR mode: Introduces intervals between semi-automatic shots to respect the DMR rules on some fields.

- Low battery voltage alarm: Dedicated for Li-Po and Li-Ion batteries. When the battery voltage drops to a dangerously low level, the user will be alerted by short beeps that repeat every minute. This can also be turned on and off freely.

- Diagnostic system: Constantly monitors the replica and the mosfet itself. If there is a problem, it immediately informs you what it might be, making troubleshooting a lot easier.

- Electronic fuse: It will save your replica and battery in case of serious malfunction. It will automatically disconnect the battery if a short circuit or blocked motor is detected.

Programming of all settings is done exclusively using quick and easily memorable sequences of fire selector switching and trigger presses supported by beeps and multi-colored LEDs. This allows you to change settings at any time, in seconds, even under enemy fire. All settings are set independently for each switch position, so you can program the mosfet exactly as you want, for example, semi on semi and binary trigger on auto.

ETU ++ works flawlessly with any battery from 7V to 17V. It can also be used with the most extreme configurations. The maximum rate of fire is 50 RPS.