Mosfet professionally made for airsoft electric guns.
The device increases the replica's rate of fire and the battery lasts longer than the basic wiring.

Specifications:

• Pre-welded cables allow for quicker and easier installation in airsoft replica, it is long enough for all types of weapons. Just cut the cables to the required length and connect the connectors (included in the package)
• Four high quality 1.5qmm (awg16) power cables covered with mppe insulation and two 0.34qmm signal wires (awg22) are pre-soldered onto the devices
• Board covered with protective coating, protects the device from water
• If you want to use your own cables, choose the variant without wiring
• Designed for springs up to m210 (equivalent for 150a single shot current or 50a burst fire for max. 30 seconds)
• Specified for common batteries up to 17v (ni-xx 8.4 - 12v, li-po 7.4 - 14.8v)
• 6-wire connection
• Device dimensions 25mm x 12mm x 7mm
• No power consumption in idle mode
• No spark on the switch contacts
• In automatic fire mode, the piston stops in a random position thanks to the mechabox design
• For correct operation it is necessary to have a functional cut off lever, selector plate, reverse latch, trigger and trigger lock, as in a standard gearbox

• Device with wiring
• Male deant connector
• 30a mini fuse
• 4x 2.8mm female faston
• 6x black heat shrink tube 3,2mm - length 20mm
• 3x black heat shrink tube 4,8mm - length 20mm
• Installation manual in English