Mosfet professionally made for airsoft electric guns.
The device increases the replica's rate of fire and the battery lasts longer than the basic wiring.
After installation it is fully integrated into the version 3 gearbox instead of the original trigger contacts, compatible with the tokyo marui standard.

Specifications:

• Mosfet made on trigger contacts of the company shs
• Easy installation inside gearbox version 3
• Pre-welded cables allow for quicker and easier installation in airsoft replica, it is long enough for all types of weapons. Just cut the cables to the required length and connect the connectors (included in the package)
• The devices are pre-soldered 2 high quality 1.5 qmm black wires (awg16) with thin and hard mppe insulation, 300 mm length to the motor and 700 mm to the battery. 0.34 qmm blue wire (awg24) with a length of 1000 mm is used for connection at any point of the red wire
• Included in the package is a 1000mm 1,5qmm (awg16) red wire with thin and hard mppe insulation
• Board covered with protective coating, protects the device from water
• Designed for springs up to m160 (equivalent for 75a single shot current or 25a burst fire for max. 30 seconds). For a higher load please use mosfet ii (it is external to the gearbox)
• Specified for common batteries up to 17v (ni-xx 8.4 - 12v, lipol 7.4 - 14.8v)
• No power consumption in idle mode
• No spark on the switch contacts
• In automatic fire mode, the piston stops in a random position thanks to the mechabox design
• For correct operation it is necessary to have a functional cut off lever, selector plate, reverse latch, trigger and trigger lock, as in a standard gearbox

• Mosfet on trigger contacts with wiring
• Trigger switch
• Male deant connector
• 30a mini fuse
• 4x 2.8mm female faston
• 6x black heat shrink tube 3,2mm - length 20mm
• 3x black heat shrink tube 4,8mm - length 20mm
• Installation manual in English