The Lancer Tactical Hybrid Series features the same ProLine interior but with one key difference. Instead of a full metal body, the hybrid AEGs feature nylon polymer upper and lower shells, making your rifle light yet solid. And unlike the Lancer Tactical G2 rifles, the AEGs from the Hybrid series feature a full metal riser grip. If you want the best of both worlds, Hybrid is the way to go. The 6.03mm stock tightbore barrel further increases reach and FPS, and an injected polymer rotary hop-up adjusts the BB's spin effortlessly for maximum accuracy. Upgraded with a 18: 1 reinforced steel gear set to provide faster cycle speed and 8mm bushings to improve the operating smoothness of your gears. This improved interior increases shot-to-ball consistency with minimal wear on your interior. The powerful 25k high torque motor is tuned for maximum efficiency with low resistance copper wiring and an additional battery protection feature! When low voltage is detected from a discharged battery, an automatic shutdown prevents the supplied batteries from fully discharging, greatly increasing battery life and longevity. Replace your springs and alter your FPS without opening the gear! A true quick-change spring system allows adjustment from the CQB to the outside and vice versa by unlocking the mechanism fixed inside the stock tube.

Lancer “Fast Trigger”: The AEG Lancer Tactical Hybrid Gen 2 are also fully equipped with the Lancer Fast Trigger just like the ProLine series. Modeled with a flat bladed trigger design, an ETU and a MOSFET all located within the shifter, the additional wiring has been reduced, amplifying the trigger response. The Lancer Fast Trigger pushes around 20-25 RPS and fires consistently within a range of 2-3 FPS.

The most important evolution of the new Proline Hybrid is undoubtedly its ETU GEN2 electronic trigger: this trigger allows for greater responsiveness, finer trigger stroke sensitivity, low voltage battery protection, full shift cycles, a start of much faster recovery thanks to its magnetic sensor loop detection, etc… a small revolution, always at an affordable price.

Mechanics:

18: 1 ratio steel gears (specific gear piston to work with ETU GEN2)
Delayer
Bearings 8mm
14-tooth steel piston
Red anodized cylinder for a better surface finish
High-speed motor with 25000 rpm Neodyn magnet
QD spring steel guide on bearings
Quick Spring Change (QD)
Recommended battery: 11.1V type CQB (not included)

Internal parts:

Low resistance shielded wiring
High speed metal trigger
ETU GEN2 electronic trigger lock with protection mosfet integrated in the electronic board
16AWG shielded wiring (rear)
6.03mm precision barrel in polished brass
Hop-up block with center wheel (Gen 2)
50 ° hop-up joint

External parts:

High density polymer body
Monobloc metal outer barrel
Foldable nylon fiber front sight
Ergonomic metal trigger guard
Slim M-LOK aluminum handguard
Crane type stock
Stock tube in polymer
Steel cocking lever
Steel magazine catch
Semi and full auto

Dimensions:

Length: 800mm closed stock / 880mm extended stock
Weight: 2400g

Equipment:

1x M4 Interceptor Hybrid rifle
1x300 Round Metal Hi-Cap Magazine
1x Set of rear sights